Zanussi ZWY 1100 Notice D'utilisation page 10

Problems
The appliance fills but
empties straight away:
The appliance doesn't
rinse or doesn't empty:
The appliance doesn't
spin:
You have found water
around the appliance:
The washing results are
not satisfactory :
The appliance vibrates, is
noisy:
The wash cycle is much
too long:
The appliance stops dur-
ing a wash cycle:
The lid doesn't open at
the end of the cycle:
Softener runs directly into
the drum when filling the
dispenser box:
10
• the drainage U-piece is fixed too low (see "Installation").
• the drain hose is blocked or bent,
• the drainage filter is obstructed (see "Care and cleaning "),
• the out of balance detector has been activated: washing is unevenly dis-
tributed in the drum,
• the "Drain" programme or "Night Cycle" or "Rinse hold" option have been
selected,
• the height of the drainage U-piece is unsuitable.
• balance problem with the laundry load: add more laundry or manually adjust
the items in the drum.
• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn't attached correctly,
• the water inlet hose is leaking.
• the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn't enough detergent.
• all packaging have not been removed from the appliance (see "Installa-
tion"),
• the appliance isn't level and is unbalanced (see "Installation"),
• the appliance is too close to the wall or furniture,
• washing is unevenly distributed in the drum, the load is too small,
• the appliance is in running in period, noise will disappear with time.
• the water inlet filters are dirty (see "Care and cleaning "),
• the power or water supply has been cut off,
• the motor overheating detector has been activated,
• the water inlet temperature is lower than usual,
• the foam detection security system has been activated (too much deter-
gent) and the washing machine has begun draining the foam,
• the out of balance detector has been activated: an extra phase has been
added to distribute washing more evenly in the drum.
• the water or electricity supply is defective,
• a "Rinse hold" has been selected,
• the drum shutters are open.
• the temperature inside the drum is too high,
• the lid unlocks 1 - 2 minutes after the end of the cycle.
• you have gone past the MAX indicator.
Causes
www.zanussi.com