Private Exchanges/T-Net; Inserting An Automatic Pause - switel D6010 Mode D'emploi

7

Private exchanges/T-NET

You can use the "R" signal button
exchanges.
If you have connected your telephone to a private exchange, you can use
all the facilities such as call transfer, automatic recall, etc. The "R" signal
button gives you access to these facilities. The FLASH time "120ms" or
"300ms" will be required on a private exchange (Adjustment, see 8.4).You
can find out from the dealer from whom the equipment was purchased
whether your telephone will work on your private exchange without any
problems.
7.1

Inserting an automatic pause

With some private exchanges, it is necessary to dial a certain number (e.g.
"9" or "0") in order, after a short pause, to obtain a dialling tone for an
outside line on the extension.
An automatic dialling pause of ca. 3 seconds can be stored in the
phonebook along with the number. When entering the number, hold the
button pressed at the required point until the P indicator appears in the
display. Then enter the remaining digits of the phone number and save the
number in the usual way.
- Private exchanges/T-NET -
on your telephone on private
85