Option 1: Weed Killer; Option 2: Specific Weed Killer; Option 3: Paint Removal - Batavia MAXXHEAT BT-HG005 Mode D'emploi

English
To turn off the appliance:
7.3
— Press the on / off switch (1) again. The
unit is now switched off.
To install the nozzle:
7.4
The nozzles can easily be pushed over the
hot air nozzle. Never touch the nozzles
during or immediately after use of the
device. The nozzles are very hot.
Rotating handle:
7.5
The device has two handle positions (see
Fig. D) Position 1 is suitable for killing
weeds and igniting the BBQ. In position 2,
the device can be used as a hot air gun.
To change the handle position:
• Press the release button (8).
• Turn the handle to the desired position.
• Make sure that the release button has
been locked again.

8. Option 1: Weed killer

Assembly of the telescopic extension
8.1
handle:
Attach the extension handle to the device.
Make sure that the extension handle firmly
clicks into position.The telescopic extension
handle can be adjusted easily to the
required length. Turn knob A, reposition the
handle to the desired length and then turn
knob A securely.If using the device as a
weed killer you must use the extension
handle.Hold the weed killer firmly by holding
the end of the extension handle.
Use:
8.2
• Ensure the extension handle is firmly
fixed onto the device and that the device
is turned off.
• Turn the device to position 1 (see Fig. D).
• Install the nozzle (11) to destroy weeds.
• Insert the plug into the socket.
• Check to ensure the nozzle is not
blocked before turning the device on.
• Set the temperature to setting II or III.
• Allow the device about 45 seconds to
warm up.
8
• To eliminate weeds, hold the nozzle over
the weeds for about 5 seconds. During
these 5 seconds the cell structure of the
weed is destroyed. As a result, the weed
dies within a few days.
• It is not necessary to completely burn
the weeds, 5 seconds is more than
sufficient.
• For an efficient treatment the nozzle
should be held around 0 to 5 cm above
the weeds.
• The effects are not visible immediately
but will take a while before they can be
seen. It is more of a long-term effect.

9. Option 2: Specific weed killer

• Ensure the extension handle is firmly
fixed onto the device and that the device
is turned off.
• Turn the device to position 1 (see Fig. D).
• Install the Heat-pin (15) to heat-treat the
weed.
• Insert the plug into the socket.
• Set the temperature switch in position
"III".
• Allow the device about 60 seconds to
warm up.
• Position the heat-pin in the middle of the
weed, and push the pin into the weed, up
to the mark, and retract the heat-pin
from the soil after about 2 seconds.
• The effect of the treatment will not be
immediately obvious as it can take sev-
eral days before it is visible, but it will
have a long-term effect.
• Use the heat-pin only on the lawn and
loose soil. Do not use on rocky soil as
the heat-pin could break off.
• On some occasions, a small brown spot
of burned grass can occur, but this will
recover very soon.

10. Option 3: Paint removal

The paint removal is always done without
the use of the extension handle. Remove
the extension handle by pressing and
releasing button (7) and pulling the exten-
sion handle from the device.
The paint removal can be used for various
purposes, such as: