Troubleshooting - switel CD7702 Mode D'emploi

16

Troubleshooting

Should problems arise with the telephone, refer to the following information.
In the case of claims under the terms of guarantee, contact your sales outlet. There is a 2 year period of
guarantee.
Faults
Nothing appears in the display −
The caller's number is not dis-
played despite CLIP function
No connection to base station
possible
No telephone calls
possible
Connection is disturbed or cut
off
The charging control lamp
does not light up
The battery icon flashes in the
display after a few hours
Display is dark
SMS message cannot be sent
− Troubleshooting −
Corrective measures
Handset is not switched on.
− Batteries are empty or defective.
− Caller has not enabled the number transfer by the telephone network pro-
vider.
− Check that the handset has been registered on the base station with the
correct PIN.
− The telephone line is not connected properly or is defective. Only use the
telephone connection cable supplied.
− Test whether the telephone connection is in order by using another tele-
phone.
− The power adaptor plug is not plugged in or there is a complete power
failure.
− Batteries are empty or defective.
− The handset is too far from the base station.
− The handset is too far from the base station.
− The base station is in an unsuitable location.
− Place the handset correctly in the base station, clean the contact surfaces
on the handset and the base station with a soft, dry cloth.
− Place the handset in the base station for 14 hours. If this does not help,
replace the rechargeable standard batteries.
− Caused by direct sunlight, allow handset to cool down.
− Check the SMS centres have been entered correctly. Ask your telephone
network provider.
− Your telephone is integrated in a PABX system.
− Request the telephone network provider to activate the SMS services.
121