Kettler TOUR 600 Instructions De Montage page 5

– EN –
ment.
! WARNING!
Before beginning your program of training, study
the instructions for training carefully.
! WARNING!
All electric appliances emit electromagnetic ra-
diation when in operation. Please do not leave especially ra-
diation-intensive appliances (e.g. mobile telephones) directly
next to the cockpit or the electronic controlsystem as otherwise
values displayed might be distorted (e.g. pulse measurement.
! WARNING!
Ensure that the power cable is not pinched and
that no-one can trip over it.
! WARNING!
This training device is for home use only.
Do not use a multiple power socket for the running belt. If an
n
extension cable is being used, ensure that it complies with the
VDE regulations.
Unplug the power cord of the device from the socket if not used
n
for a longer period.
Exercise has been designed in accordance with the latest stan-
n
dards of safety. Any features which may have been a possible
cause of injury have been avoided or made as safe as possi-
ble.
ncorrect repairs and structural modifications (e.g. removal or
n
replacement of original parts) may endanger the safety of the
user.
If the equipment is in regular use, check all its components
n
thoroughly every 1 -2 months. Pay particular attention to the
tightness of bolts and nuts.This applies especially to the secu-
ring bolts for saddle and handelbars.
Before beginning your program of exercise, consult your doctor
n
to ensure that you are fit enough to use the equipment. Base
your program of exercise on the advice given by your doctor.
Incorrect or excessive exercise may damage your health!
Any interference with parts of the product that are not descri-
n
bed within the manual may cause damage, or endanger the
person using this machine. Extensive repairs must only be car-
ried out by qualified Staff
Our products are subject to a constant innovative quality as-
n
surance. We reserve the right to perform technical modificati-
ons.
In case of enquiry, please contact your KETTLER dealer.
n
In choosing the location of the apparatus, ensure a sufficient
n
safety distance from any obstacles. The apparatus must not
be mounted in the immediate vicinity of main passageways
(paths, doorways, corridors). The safety distance surrounding
must extend at least 1 meter further than the practice area.
This training device has to be set up on a horizontal surface
n
under all circumstances. Place rubber or straw mats under it
to deaden any noise or impacts. Only for appliances with
weights. Avoid powerful oscillations of the dumbbells!
When mounting the product please take the recommended tor-
n
que information into account (
The actual human performance can differ from the mechanical
n
performance shown.
= xx Nm).
Art.-Nr. EM 1013-200, EM1014-400:
The training device corresponds with DIN EN ISO 20957-1/DIN
n
EN 957-5, class HA. It is therefore suitable for therapeutic use.
The device requires a supply voltage of 230V, 50 Hz.
n
Connect the power cord with a protective contact socket.
The device may only be used with the power supply units de-
n
livered
HRC Training Program
! WARNING!
If you lose the pulse signal, the performance of
the device will remain constant for approx. 60 seconds and is
then slowly adjusted downwards. Please check your pulse
measuring system (ear clip, hand pulse or chest belt) so that
the pulse signal of the electronics can be entered again.
5