Triton 2000 Série Instructions D'utilisation Et Consignes De Sécurité page 64

The four most common saw sizes are printed on the end panels for reference. In
height is being set for a 235 mm (9 1/4") saw. The top edge of the red indicator is the reference.
Leaving two bearings out of the channels enables you to slide the table in from the side without the
tip of the blade scratching the paintwork on the table. Another method is to raise the saw blade a
little, and then lower it again when the table is in position.
The fence may be a little tight - especially when new. Do not loosen the screws fastening the four
plastic feet. Rather use a block of wood to gently tap the fence home. If you do have to loosen the
screws, 1 / to 1 / a turn should be enough. The plastic feet are difficult to re-seat if undone.
4 2
Page 10
SETTING UP THE CROSSCUT MODE
Remove the overhead guard and rip fence and store them as
shown on Page 28.
Remove the table and place it to one side for the moment.
Adjust the height of the aluminium table support rails inside the
front and rear panels, to suit your saw.
The rails are meant to be a snug fit inside the panels and may
need a sharp tap to free them. The adjustment is a bit easier
without the table in position.
1
4
Turn the saw right way up but leave two of the
bearings on top of the channels.
in from the side until the centre slot is directly
below the blade. Lock the table by pushing the
latches fully home into the cut outs in the table
support rails. (The red indicators on the latches
must fully disappear from view).
Slide the chassis to the rear panel and the two free
bearings will drop into the channels.
2
Always make sure that all four bearings are
!
back inside the channels before making a cut.
The tip of your blade should be just entering the
slot (by 1 - 2 mm) and it should be approximately
central in the aluminium track.
Slump adjustment on Page 13.
3
FITTING THE CROSSCUT FENCE
Fit the Crosscut Fence (H) to the four T-
slots in the table, with the MDF sub fence
closest to the saw. Pull the fence towards
the rear panel as far as it will go.
To release the fence, hold down each red
plastic catch while pushing the fence
towards the saw.
5
1
1
the table
2
Slide the table
3
If not, see Saw
4
5