Triton 2000 Série Instructions D'utilisation Et Consignes De Sécurité page 57

STEP 1: Fit the Legs (D) to each End Panel (B & C). Before fitting, check that each leg splays
outwards as shown, and that you have fitted the Leg Locking Pin (a) with the spring-
loaded ball facing outwards. Tighten the bolts so that the legs are firm, but still free to
pivot. Use four M8 x 50 bolts (f), eight washers (d) and four M8 Nyloc nuts (e).
STEP 2: Fit the Base Channels (F) as shown. Tighten the bolts until the leg brackets close firmly
on the base channels. Do not overtighten. The Nyloc nuts used are vibration proof and
won't come undone. Use four M8 x 50 bolts, eight washers and four Nyloc nuts.
STEP 3: Fit the Flange Nuts (c) inside the Bearing Channels (E) and fit the bearing channels to the
end panels. They should click into position when pushed up from below. Fully tighten the
bolts. Use four M8 x 16 bolts (b), four 8mm washers (d) and four flange nuts.
STEP 4: Fit the plastic components (r, g & p) as shown, and then fit the Rip Fence (I).
Insert Flange Nuts into
the ends of the
bearing channels.
(c)
(b & d)
(B)
(g)
STEP 4
FENCE LOCKING: You only need use 2 locking levers - one at the front and one at the back. The
locking position of the levers is factory preset. To adjust, simply loosen or tighten the nut at the
bottom of each clamp assembly. The levers should reach at least the half way point in their arc of
travel before tightening up. Lubricate the cam faces occasionally with light machine oil.
(I)
(E)
(e)
(d & f)
(a)
STEP 4
(C)
(F)
!
Check that each leg and leg
locking pin is facing the right
way before fitting. Depress
and hold the spring-loaded
ball when fitting the leg.
!
Note the
correct
positions
for the
washers.
(D)
(r)
STEP 4
STEP 4
Page 3
STEP 3
STEP 2
STEP 1
(p)