Error Messages - ROBBE Power Peak QUAD EQ-BID Notice D'utilisation

11.

ERROR MESSAGES

Power Peak ® Quad EQ-BID is equipped with special safety features to ensure safe and
reliable charging and discharging operation. As soon as a fault occurs, a corresponding
message appears in the display and the piezo buzzer emits a shrill warning tone. After
eliminating the cause of the problem, the following error messages can be acknowledged/
erased by pressing any button.
Operating Instructions
Power Peak ® Quad EQ-BID
Input voltage outside permitted range (11 - 15 Volt)
Charging or discharging started without connection to
battery, make connection
Battery connected with polarity reversed, check
connection
Break in charging/discharging current circuit, check
connection
Short-circuit in charging/discharging current circuit,
check connections
Battery/output voltage too high, check number of
cells
Battery/output voltage too low, check number of cells
BID chip/key separated from charger during active
operation, stop procedure, check connection to chip
and restart.
Voltage level of connected cell(s) has risen above
4.3 Volt.
Voltage level of connected cell(s) has fallen below
2.75 Volt for LiPo and LiIo or 2.0 Volt for LiFe.
Voltage sensor lead is not connected
21
Order No.
8506