Publicité
Les langues disponibles
Les langues disponibles
The cooker hood has a cable with earthed plug and must be connected to an earthed wall socket.
Amperage and absorption are shown on the specification label on the inside of the cooker hood.
Replacement of the connection cable is to be done by a qualified installer.
5
PLACE THE SUCTION UNIT AND FINISHING
•
Place the fat filter (7900.020) into the suction unit (990.984). The fat filter will lie at a slant in the suction unit.
•
Place the tilt lid (990.985) onto the suction unit.
•
Take the complete suction unit with the fat filter and press it down the suction opening of UP_SIDE
•
The motor of the appliance will start operating i mmediately. Use both hands - one at the front and one at the rear of the
suction unit - to press down and lock the suction unit into place. The motor switches off when the lid on the suction unit
is horizontal.
•
Check the functioning of the installed appliances. Use sealant (not supplied) to close the gaps between UP_SIDE, the
work surface and the other appliances. This prevents cooking liquid, condensation, etc. from entering the space between
the work surface and the cabinets.
6
ACCESSORIES
Adapter for flat ducting (item number 7901.052)
The adapter makes it possible to continue with a flat duct directly from the cooking hood. In case of a cabinet with a limited
depth, this adapter is the ultimate solution to allow installation with flat ducts. The adapter is mounted unto the outlet of UP_
SIDE to which a flat duct can be connected directly. More information for connecting the adapter can be found in the mounting
instructions for the adapter.
Recirculation
UP_SIDE can be connected to an exhaust box with a monoblock recirculation filter. The choice can be made between 3
exhaust boxes, being:
-
7900.400 – 140 mm height for building in into the plinth
-
7910.400 – 98 mm height for building in into the plinth
-
830.400 SS/ 831.400 WHITE – 270 x 500 x 295 mm
More information for connecting the exhaust box can be found in the mounting instructions for the exhaust box concerned.
EN 25
Publicité
