Publicité
Les langues disponibles
Les langues disponibles
Milled groove:
X =
526 mm
Y = the total width of all appliances + space for the silicon (3 mm between the table top and the appliance, 2 mm between 2
appliances)
Z =
the depth of the milled groove = the thickness of the glass of the cooking plate + 1,5 mm (tolerance -0/+0,5 mm)
Example with 2 x UP_SIDE and 3 domino elements:
Domino 2 zone (380 mm) + UP_SIDE (110 mm) + Domino 2-zone (380 mm) + UP_SIDE (110 mm) + Domino wok (380 mm)
Flush mounting:
Opening
X = 502 mm
Y = (380 mm + 2 mm + 110 mm + 2 mm + 380 mm + 2 mm + 110 mm + 2 mm + 380 mm) - 10 mm
Milled groove
X = 526 mm
Y = 3 mm + 380 mm + 2 mm + 110 mm + 2 mm + 380 mm + 2 mm + 110 mm + 2 mm + 380 mm + 3 mm
1.3
CHANGE THE EXHAUST DIRECTION
The exhaust direction can be changed dependent on the exhaust direction of the motor casing (left or right of UP_SIDE's
suction opening).
•
A: Remove the 8 screws of the sound-insulating outlet .
•
B: Turn the electronics box by removing the 4 screws and by placing back the box upside down (cables facing up).
(7901_M3) Remount using the 4 screws.
•
C: Turn the outlet 180° again with the 8 screws.
A
1.4. POSITION DES ABDECKRAHMENS äNDERN
Um das NOVY Logo nach vorne zeigen zu lassen, können Sie den Abdeckrahmen drehen. Ziehen Sie dazu den Rahmen
nach oben, in dem Sie vorne und hinten unter den Edelstahl greifen. Drehen Sie den Rahmen in die gewünschte Position und
drücken Sie ihn zurück in die Arretierung.
2
MOUNTING
Attention! When using the adapter (7901.052), this should be mounted first unto UP_SIDE, before placing UP_SIDE into the
table top (more information about the adapter 7901.052 is to be found at point 6).
2.1
SURFACE MOUNTING
Stick the delivered grey insulating tape (661-050) on the edge of the opening.
Determine the position of UP_SIDE and put it at the correct place in the opening.
Proceed with 2.3
B
C
EN 21
Publicité
