Setting; After Using The Self-Clean Function; Care And Cleaning; Cleaning Products - Blaupunkt 5BD350 Série Notice D'utilisation

Setting

Once the cleaning level has been selected, set the oven.
Select the self-cleaning function with the function control
1.
knob V .
Set the required cleaning level using the
2.
The display panel will show the cleaning level and the
symbol. Self-cleaning starts within a few seconds.
The oven door locks shortly after the function has started. The
display panel displays H . Only when the
can the oven door be opened again.
Self-cleaning has ended.
The display panel will show
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H symbol on the display panel turns off.
Changing the cleaning level
The cleaning level cannot be changed once it has started.
Stopping the self-cleaning
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H symbol on the display panel turns off.

Care and cleaning

If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
Different colours may be seen in your front panel due to the
■
various materials used in its manufacture, such as glass,
plastic and metal.
Dark patches in the door's glass panel may seem to be dirt
■
but they are in fact reflections from the oven light.
Enamel burns at very high temperatures. This may cause
■
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.

Cleaning products

Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
abrasive or acidic cleaning products
■
strong products containing alcohol
■
scourers or hard sponges
■
high-pressure or steam cleaners.
■
Wash new dishcloths thoroughly before use.
@ or A sensors.
H symbol turns off
‹‹ : ‹‹ . The oven will stop heating.
Delaying the end time
The oven allows you to programme the self-cleaning end time.
Self-cleaning can therefore be programmed at night for
example, leaving the oven free for use during the day.
Programme as described in section 1 and 2. Before starting the
self-cleaning, press the
end time with the
x
The oven is set to standby. The display panel will show the
cleaning level and the
cleaning level and the
switches off.
Viewing the time settings
To view the duration of the cleaning level or the end time of the
self-cleaning press the
symbol lights up. The corresponding value will be shown for a
few seconds on the display panel.

After using the self-clean function

Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
Zone
Front panel
Stainless
steel
Glass
panel
Display
Glass panels
on oven door
Door covering Only use products specially for cleaning stain-
Inside the
oven
sensor three times and delay the
0
or sensors.
@ A
y symbol. When self-cleaning starts, the
x symbol are shown. The
0 sensor repeatedly until the required
Cleaning products
Hot water and a little soap:
Clean with a dishcloth and dry with a soft cloth.
Do not use a glass cleaning product or a glass
scraper.
Hot water and a little soap:
Clean with a dishcloth and dry with a soft cloth.
Immediately remove any water marks, grease,
cornflower or egg white stains since corrosion
could occur underneath these marks or stains.
Special products for the care of stainless steel
which are suitable for hot surfaces may be
obtained from Technical Assistance Service
centres and specialist retail outlets. Use a very
fine soft cloth to apply the cleaning product.
Glass cleaning products:
Clean with a soft cloth. Do not use a glass
scraper.
Glass cleaning products:
Clean with a soft cloth. Do not use alcohol, vin-
egar or other abrasive or acidic cleaning prod-
ucts.
Glass cleaning products:
Clean with a soft cloth. Do not use a glass
scraper.
less steel (these can be obtained from the
Technical Assistance Service or from specialist
shops). Follow the manufacturer's instructions.
Hot water with a little soap or water and vine-
gar:
Clean with a dishcloth.
If very dirty, use a stainless steel scourer or
special oven cleaning products. These must
only be used when the oven interior is cold.
Whenever possible, use the self-cleaning func-
tion. See the chapter on the Self-cleaning func-
tion.
y symbol
37