Generally
This appliance is for private use only and must not be used commercially. Please read
the instruction manual carefully and keep it at a safe place. When the appliance is
given to another person the instruction manual should be passed to that person, too.
Only use the appliance as described in the instruction manual and pay attention to
the safety information. No liability for damages or accidents will be accepted, which
are caused by not paying attention to the instruction manual.
Cautions
∙
Do not plug with wet hands.
∙
Do not plug into a socket where several other appliances are plugged in.
∙
Do not use if the plug cord is damaged or when the power plug does not fit the
socket securely.
∙
Do not modify the parts, or repair the unit by yourself.
∙
Do not use the unit near a flame or wet places.
∙
This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capacities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety
∙
Children should be supervised to ensure that they do not play with the appliance.
Do not place on unstable surfaces.
∙
Do not carry the unit when the pot or the pan is on it.
∙
Do not heat the pot empty or overheat it.
∙
Do not place metallic objects such as knives, forks, spoons, lids, cans, and aluminum
foils on the top plate.
∙
Use the unit with sufficient space around it. Keep the front side and either right or
left side of the unit clear.
∙
Never use the unit on carpet or tablecloth (viny1) or any other low-heat-resistant
article.
∙
Do not place a sheet of paper between the pot or the pan and the unit. The paper
may get burnt.
∙
If the surface is cracked, switch off and take to the service center immediately.
∙
Do not block air intake or exhaust vent.
∙
Do not touch the top plate shortly after removing the pot or the pan, as
the top plate will still be very hot.
∙
Do not place near objects which are affected by magnet, such as: radios, televisions,
automatic-banking cards and cassette tapes.
∙
The supply cord must by replaced by qualified technicians.
∙
The appliance is not suitable to be used with an external timer or a separate remo-
te control.
28
How to use
∙
Only use pots and pans suitable for induction cookers. Place the pot/pan (min. dia-
meter 12cm) in the middle of the plate.
∙
No bigger pots then the ring diameter (16,5cm) can be placed on the induction
cooker.
∙
Plug in the appliance.
∙
Touch the "ON/OFF" button. A signal can be heard.
∙
When there is no selection of program or temperature within one minute the appli-
ance will switch off automatically.
∙
If no pot or a pot not suitable for induction is placed on the appliance a signal can
be heard, in the display "E1" can be seen and the appliance will switch off after ca
30 sec.
Power:
Touch the „On/Off" button and then the power button. At the display "1" is shown.
By slightly touching the "On/Off" button the power can be changed from 1-7.
The appliance is equipped with a overheat protection.
When pots get too hot the appliance will be switched off and in the display E7 occurs.
In that case touch the "On/Off" button and cool the appliance down for some minu-
tes. After that the appliance will work without any problem.
All power steps are suitable to be used for cooking water and soups.
Should meat or vegetables roasted then please use the temperature function to
achieve the intended result.
Temperature:
Touch the „On/Off" button and then the temperature button. At the display "60" is
shown. By slightly touching the temperature button can the temperature be changed
in different steps up to 240°C. The integrated sensor keeps the temperature at this
level.
Timer:
After the power or the temperature is chosen it is possible to use the Timer function
by touching it. In the display "010"min is shown. By touching the Timer button the
time can be changed in 10min steps (max 2h). The time counts down in minute steps
and after the time runs out the appliance will stop working.
When Power or temperature should be changed the Timer must be reprogrammed.
29