12�2 Warranty Exclusions - Truma iNet X Mode D'emploi

Truma iNet X Panel / Truma iNet X Pro Panel
Manufacturer or the authorised service partner� If the
appliance is no longer manufactured at the time of de-
fect notification and if replacement delivery has been
opted for, then the Manufacturer may deliver a similar
product�
If the Manufacturer remedies a defect under its War-
ranty commitment, the term of the Warranty shall not
start again with regard to the repaired or replaced parts;
rather, the original warranty period shall continue to be
applicable to the appliance� Only the Manufacturer itself
or an authorised service partner shall be entitled to con-
duct a warranty job� Any costs that occur in the event
of a warranty claim shall be settled directly between
the authorised service partner and the Manufacturer�
The Warranty does not cover additional costs arising
from complicated removal or installation jobs on the
appliance (e�g� dismantling of furnishings or parts of
the vehicle body), and neither does it cover travel ex-
penses incurred by the authorised service partner or the
Manufacturer�
No further-reaching claims shall be permitted, espe-
cially damage claims presented by the Consumer or
third parties� This shall not affect the provisions of the
German Product Liability Act (Produkthaftungsgesetz) �
47000-00083 · 01 · 11/2021
The voluntary manufacturer's warranty does not affect
the Consumer's legally valid claims for defects against
the seller in the relevant country of purchase� In indi-
vidual countries there may be warranties that can be
issued by the relevant dealer (official distributor, Truma
Partner)� In such cases the warranty can be implement-
ed directly through the dealer from whom the Consum-
er bought the appliance� The warranty regulations of
the country in which the appliance was purchased by
the Consumer for the first time shall also be applicable�
12.2 Warranty exclusions
No warranty claim shall be applicable under the follow-
ing circumstances:
Improper, unsuitable, faulty or negligent use and any
•
use that is not compliant with the intended purpose
Improper installation, assembly or commissioning,
•
contrary to operating or installation instructions
Improper operation or operation contrary to operat-
•
ing or installation instructions, particularly any disre-
gard for maintenance, care or warning notes
Instances where installations, repairs or any other
•
procedures have been conducted by non-authorised
parties
Consumable materials and parts which are subject
•
to natural wear and tear
WARRANTY
EN 31