Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Installation
11
10
9
8
1 Component support screw (3 pce)
2 Recess for pressure plate tab
3 Pressure plate screw (10 pce)
4 Cylinder tab
5 Earth conductor
6 Terminal (power cable)
7 Terminal (heat pump manager control cable)
8 Cable entry
9 Immersion heater connector
10 Cable retainer (4 pce)
11 Controller screw (2 pce)
12 Temperature selector
f Position the pressure plate so that the tab fits into the plastic
f
casing recess.
f Secure the pressure plate with the 10 screws (tightening
f
torque 8 Nm).
f Assemble the drain valve with the flat gasket provided (tight-
f
ening torque 20 Nm).
f Secure the component support with the 3 screws.
f
f Screw in the 2 terminals.
f
f Secure the earth conductor to the cylinder tab with the
f
self-tapping screw.
f Fix the cables into the cable retainers.
f
f Route the limiter sensor and the controller sensor into the
f
sensor tube until the limiter sensor engages. Note the inser-
tion depths of the controller-limiter combination (see chapter
"Specification / Dimensions and connections").
f Insert the plug into the immersion heater.
f
www.stiebel-eltron.com
168843_SBP_100_de_en_fr_cs_pl.indb 27
12
1
2
3
4
5
7
6
SBP 100|
27
04.09.2017 13:52:52
Publicité
Chapitres
Table des Matières
Dépannage
