Ibiza sound STANDUP18-MAX Manuel D'utilisation page 5

MANUAL - STANDUP18-MAX
33. B System BT input selector (BT searching name: STANDUP18-MAX-B)
34. B System Line input selector
35. 35.B System FM input selector
36. B System Previous key, keep pressed to lower the volume
37. B ystem Play key
38. B System Pause key
39. B System next key, keep pressed to increase the volume
REMOTE CONTROL
1. A System USB/SD card input button
2. A System BT input button
3. B System USB/SD card input button
4. B System BT input button
5. A System FM input button
6. A System LINE input button
7. B System FM input button
8. B System LINE input button
9. A System volume increase
10. A System volume decrease
11. A System Equalizer
12. B System Equalizer
13. B System volume increase
14. B System volume decrease
15. A System play again
16. B System play again
17. Mute volume
18. A System auto scan for channels
19. B System auto scan for channels
20. A System USB/SD card song select
21. B System USB/SD card song select
22. A System previous song
23. A System next song
24. B System previous song
25. B System next song
26. A System play
27. A System Pause
28. B System play
29. B System Pause
CONNECTIONS
1. FM antenna jack
2. Power input
BLUETOOTH CONNECTION
The procedure is the same for both systems, just select the system you want to operate.
ENTER OR RESTART BLUETOOTH
1. Press the "BT" input button on the remote control system A (or B)
2. Press the "BT" button on top of control panel A (or B)
The speaker is now in Bluetooth mode.
AUTO SEARCH AND CONNECT
The speaker will enter into auto search: it will search for the last connected device and connect to it automati-
cally if the device is switched on and within a distance of 20m. If the speaker does not connect automatically,
press the PLAY/PAUSE, PREVIOUS or NEXT button to activate the Bluetooth function and re-connect the device.
If the speaker can't find the last device or you want to connect it to a new device, start the search on the new
device and connect it to STANDUP18-MAX-A (or STANDUP18-MAX-B).
Installing the Batteries
in the remote control
Remove the battery cover
from the back of the re-
mote control as shown and
insert 2x AAA size batteries ensuring correct polarity
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of
with household waste but deposed correctly in accordance with
your local regulations. Batteries shall not be exposed to excessive
heat such as sunshine, fire or the like. When the internal batteries are not
to be used, remove them to avoid damage caused by battery leakage or
corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed.
Only replace by the same or equivalent type.
WARNING: Do not swallow the battery. Danger of chemical burns.
Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product
and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or intro-
duced into any other part of the body, contact immediately a doctor.
www.ibiza-light.com
5