Ibiza sound STANDUP18-MAX Manuel D'utilisation page 4

repair or replace components or assemblies, all of its poles must be disconnected from all sources of voltage
first. If the appliance has to be kept open and under voltage during maintenance or repairs, this work may
only be carried out by a specialist who is familiar with the risks involved and the relevant regulations.
•
Never connect the appliance directly after transferring it from a cold to a warm room. The condensation wa-
ter that forms could destroy the appliance or result in an electric shock. Allow the device to reach room tem-
perature before connecting it. Wait until the condensation water has evaporated. This can take some hours.
•
Do not place any naked flames such as those of burning candles on or next to the appliance.
•
Do not place the appliance on soft surfaces such as carpets or beds. Do not cover the air vents of the ap-
pliance. Do not obstruct the air circulation with objects such as magazines, table cloths or curtains. This
prevents the dissipation of heat from the appliance and can result in overheating.
•
Only use the appliance in a moderate climate, not in tropical environments.
•
All persons involved in operating, installing and servicing the appliance and putting it into service must be
trained and qualified accordingly and observe these operating instructions.
•
Defective mains cables may only be replaced by specialists. Danger of shock hazard!
•
Do not leave the packaging material lying around carelessly since it can become a source of danger for child-
ren playing with it.
•
The accident prevention regulations and the regulations of the employers' liability insurance association
should be observed at commercial institutions.
•
If you are not sure about the correct connection or if questions arise which are not answered by the operating
instructions, please do not hesitate to contact support or a specialist of your choice. Consult a specialist if
you are in doubt the operating principle or the safety of the product.
Top panel controls
1. Power ON/OFF
2. A B System fader
3. Equalizer
4. Equalizer
5. BASS increase/weakers
6. Mute of whole unit
7. Treble increase/weakers
8. A System LED display
9. B System LED display
10. A System Volume control knob
11. Microphone1 input
12. A System Line input
13. A System USB input
14. A System SD card input
15. Microphone volume increase/decrease
16. Equalizer
17. A System USB/SD card input key
18. A System BT input key (BT searching name: STANDUP18-MAX-A)
19. A System Line input selector
20. A System FM input selector
21. A System Previous key, keep pressed to lower the volume
22. A System Play key
23. A System Pause key
24. A System next key, keep pressed to increase the volume
25. B System Volume control knob
26. Equalizer
27. ECHO increase/decrease
28. B System SD card input
29. B System USB input
30. B System Line input
31. Microphone2 input
32. B System USB/SD card input selector
4
MANUAL - STANDUP18-MAX
©Copyright LOTRONIC 2019