Philips HF3471/01 Mode D'emploi page 8

EnglisH
8
preparing for use
setting the clock
1 Put the plug in the wall socket.
The hour indication on the display starts lashing to indicate that you have to set the clock
,
time (Fig. 6).
2 Press the menu + or - button to set the hour.
Note: You can only do this when you are in the set clock menu and when the hour indication lashes.
If this is not the case, press the MENU button, use the menu + or - button to select the set clock menu
and press the SELECT button to conirm. You are now in the set clock menu.
Press the SELECT button to conirm.
3
The minute indication starts lashing (Fig. 7).
,
4 Press the menu + or - button to set the minutes.
Press the SELECT button to conirm.
5
The appliance leaves the menu and the display shows the set clock time.
,
The appliance is now ready for use.
Note: Every time you remove the plug from the wall socket for more than approximately 15 minutes, you
have to set the clock time again in the way described above. To change the set clock time when the plug
is still in the wall socket, see section 'Menu functions' in chapter 'Using the appliance'.
using the appliance
menu functions
Below you ind a description of all functions that can be set in the menu. These functions appear in
the menu in the following order:
- Clock time
- Alarm time
- Alarm sound
- Sunset simulation
Display brightness: You can choose a display brightness between 1 and 4.
-
You can set the menu functions in the following way:
1 Press the MENU button to enter the menu (Fig. 8).
2 Press the menu + or - button to select a function (Fig. 9).
3 Press the SELECT button to enter this function (Fig. 10).
4 Press the menu + or - button to change a setting (Fig. 9).
Press the SELECT button to conirm (Fig. 10).
5
using the lamp
You can use the appliance as a bedside lamp.
1 To switch on the lamp, press the lamp on/off button (Fig. 11).
2 Press the light intensity + and - buttons to select a light intensity (Fig. 12).
You can choose a light intensity between 1 and 20.
Note: It takes approx. 1 second for the lamp to go on. This is normal, the lamp needs to heat up.
Note: The light intensity you have selected is automatically set as the light intensity level for the alarm as
well.
4222_002_7572_2_DFU-Booklet_A5_v1.indd 8 11/29/2012 10:45:19 AM