Setting Up A Direct Wi-Fi Connection - MartinLogan Crescendo Manuel De L'utilisateur

SETTING UP A DIRECT WI-FI CONNECTION

In some situations, you may not have access to a
Wi-Fi network. It is still possible to wirelessly con-
nect to the speaker and play music.
1 Turn your speaker on and wait approximately
thirty seconds.
2 For six seconds press and hold the "Wi-Fi
Setup and Status" button (located on back of
the speaker. The LED above the button will
turn solid red.
usB c
onnectIon
Compatible Apple devices, when connected via
a USB cable, can send music to your speaker
using the USB input. In addition, these devices will
charge when attached to the speaker's USB input.
Non-Apple devices, when connected to the USB
input, will charge but cannot play audio over this
connection, although you may still stream audio
from these devices via the speakers Auxiliary and
Bluetooth inputs. Many devices, when connected
to this speaker, will receive a rapid charge.
16
(c
omPatIBle
3 On your Apple iOS device, access "Settings
> Wi-Fi." If using a non-Apple device, access
the device's Wi-Fi network control panel. You
can also use a laptop with Wi-Fi capability
to complete this setup.
4 Select the speaker from the list of available
Wi-Fi networks. You may need to refresh the
network list several times before the speaker
will appear.
5 You are ready to stream music to your speaker.
a d
PPle evIces
1 Set your speaker to USB mode. Use the remote
to select USB, or repeatedly press the input but-
ton on front of the speaker until the front LED
turns white.
2 Open your iOS device music application and
start playing a song. Within your music appli-
cation, you may need to select the speaker as
the playback device.
)