Connection; Installation; Break In; Installing On A Flat Surface - MartinLogan Motion 6 Guide De L'utilisateur

C
onneCtion
WARNING! Turn your amplifier
off before making or breaking any
signal connections!
These speakers are designed with easy-to-use
push-style binding posts that accept bare wire or
pins (fig. 2). Additionally, by removing the rubber
inserts, they will accept banana plugs (fig. 3)
Assign the same color to the (+) and (–) terminals
on both the speaker and the amplifier. Make certain
that all connections are tight.
Fig. 2
i
nstallation
WARNING! Installation other
than that described in the body of
this document requires specific
documentation from MartinLogan.

BREAK IN

Allow approximately 72 hours of break-in at 90
dB (moderate listening levels) before any critical
listening.

INSTALLING ON A FLAT SURFACE

If you have a surface that provides a wide, level,
and stable platform, the speaker can be placed
directly on top. When using the speaker in this
configuration, affix the pads to the bottom of the
speaker at the rear contact points (fig. 4). Note:.
4
Fig. 1
Fig. 3
This speaker is not magnetically shielded and
therefore should not be placed directly beside or
atop a CRT television.
Fig. 4