Downloading Connection Settings From An Apple Device; Using Wi-Fi To Set Up Your Speaker; Setting Up A Permanent Ethernet Connection - MartinLogan Crescendo Manuel De L'utilisateur

Using the pin, press the recessed button for
approximately five seconds. The "Wi-Fi Setup
and Status" LED will briefly turn green and
then rapidly blink green for approximately
fifteen seconds. Then, the speaker will restart
itself and the "Wi-Fi Setup and Status" LED
will begin blinking slowly green.
DOWNLOADING CONNECTION
SETTINGS FROM AN APPLE DEVICE
1 If not already connected, wirelessly connect
your Apple device (iPad/iPod/iPhone) to your
desired Wi-Fi network (2.4GHz network only).
2 Turn your speaker on and wait approximately
thirty seconds.
3 Using a USB cable, attach your Apple iOS
device to the speaker.
4 For two seconds press and hold the "Wi-Fi
Setup and Status" button (located on back of
the speaker. The LED above the button will
begin blinking red/green. If the connected
Apple device is capable of sharing Wi-Fi set-
tings, a dialog box will appear on the Apple
device. Press "Allow." Your speaker will auto-
matically be programmed to connect to your
wireless network.
5 Upon successfully completing Wi-Fi setup, the
"Wi-Fi Setup and Status" LED will turn green.
6 Remove the Apple device from the USB cord.
7 You are ready to stream music to your speaker.

USING WI-FI TO SET UP YOUR SPEAKER

1 Turn your speaker on and wait approximately
thirty seconds.
2 For six seconds, press and hold the "Wi-Fi
Setup and Status" button (located on back of
the speaker. The LED above the button will
turn solid red or blink red.
3 On your iOS device, access "Settings >
Wi-Fi." If using a non-iOS device, access the
device's Wi-Fi control panel. You can also use
a laptop with Wi-Fi capability to complete this
setup.
4 Select the speaker from the list of available
Wi-Fi networks. You may need to refresh the
network list several times before the speaker
will appear.
5 Open a web browser and enter the address
"192.168.1.1" in the field where you would
normally enter a web-site addresses.
6 If you would like to assign a unique AirPlay
name to the speaker, enter a name in the
"AirPlay Device Name" field and hit "Apply."
Before proceeding, you may need to reload the
speaker's setup screen as described in step 5.
7 Under "Wireless LAN Settings," select your
desired Wi-Fi network from the drop down list
(2.4GHz network only). If your wireless network
requires a pass phrase, enter it into the "WPA
Pass phrase" field. If you require custom settings,
such as a different encryption method, please
select "Configure Manually" from the drop
down list and fill out the appropriate fields.
8 Click "Apply."
9 Upon successfully completing Wi-Fi setup, the
"Wi-Fi Setup and Status" LED will turn green.
10 Reconnect the device you used to set up your
speaker to its normal Wi-Fi network connec-
tion settings.
11 You are ready to stream music to your speaker.
SETTING UP A PERMANENT ETHERNET
CONNECTION
1 Turn your speaker on and wait approximately
thirty seconds.
2 Use an Ethernet cable to connect your speaker
to your router.
3 Your speaker should now appear as an avail-
able device on your network.
4 You are ready to stream music to your speaker.
15