ETATRON D.S. eOne MF Notice D'installation, Emploi Et Entretien page 62

DIAGRAM OF ELECTRICAL CONNECTIONS TO PERIPHERALS
To connect the accessories and peripherals to the pump remove the front cover "1", using a flat-tip screwdriver on the
two plastic screws, to access the terminal board (see Figure 9).
The "3" terminal board features spring terminals (there are no screws) for quick connection of the cables: press with a
small screwdriver at the "carved" square pin and insert the conductor previously stripped in the corresponding terminal.
N° Terminal
1
2
3
4
5
6
7
8
9
10
11
Description
mA (-) Input
mA (+) Input
Meter Input (-)
Meter Input (+)
Level Input (-)
Level Input (+)
Flow Switch Input (-)
Flow Switch Input (+)
Not Connected
Not Connected
Not Connected
Fig. 9 – Terminal Board
N°
Terminal
12 Not Connected
13 Not Connected
14 Not Connected
15 Not Connected
16 Not Connected
17 Not Connected
18 Not Connected
19 Alarm Relay (NO)
20 Alarm Relay (NC)
21 Alarm Relay (COM)
Description
ENGLISH 67