Publicité
Les langues disponibles
Les langues disponibles
Observe the relevant regulations in your country for
the materials to be worked.
The vacuum cleaner must be approved for
the extraction of masonry dust. WOLFF provides:
Cleaner VACUCLEAN
Insert the suction hose of the vacuum
cleaner in the adapter (18) of the machine.
4.0 Operation
Starting Operation
► Observe correct mains voltage! The voltage of
the power source must match the voltage
specified on the type plate of the machine.
Power tools marked with 230V can also be
operated with 220 V.
4.1 Handle height adjuster(F)
► The handle height adjuster (3) may be used to
set a comfortable working height.
By pulling the locking pin (3), the height/angle of the
handle may be adjusted in 5 stages.
4.2 Switching On / Off - application (G)
1. Move the handle to the working position via the
handle height adjuster (3). (F)
2. Tilt the machine (G) to prevent uncontrolled milling
3. Hold the safety switch (12) pressed.
4. Switch on the machine with one of the two levers
(1) on the underside of the grip.
5. Release the switch (12) again. (G)
6. Set down the machine carefully
Bodenschleifmaschine NEO 230, #74650
06/2014
#21014
4.3 Swivel motor (H)
► For optimal edge processing, the motor may be
swivelled to the right or to the left.
- Loosen the star-grip screw (8). Loosen the t-screw
(9) and turn the motor in the desired direction.
- Tighten the star-grip screw (8) again and tighten
the t-screw (9). Turn the hood (5) to the corres
ponding position so that the flap (14) is located
on the outside. (see item 5)
(H) a
centre, for surface processing
b/c right/left for edge processing
4.4 Slide flap / working at a wall (I)
► To work easier at edges, the hood of the
machine features a sliding flap (14).
For edge processing, the flap (14) must be turned
according to item 4.3 in the correct direction. The
flap is able to be slid forward after opening both of
the clamping screws.
This allows the edge of the wall to be milled.
5.0 Ending the work
► After ending the work and when leaving the
machine, the mains plug-in must always be
removed from the power outlet.
21
Publicité
