Publicité
Les langues disponibles
Les langues disponibles
Changing Remote Batteries
Only use alkaline batteries. Do not use zinc-carbon
batteries. If the remote will not be used for a long
time, remove the batteries as a protection against
corrosion.
To change the batteries:
1. Open the battery compartment.
2. Insert the batteries according to the polarity
marked in the compartment.
3. Close the battery compartment.
Pairing the Remote
1. Arm the machine.
2. On the machine, set the switch to the
3. Turn on the remote.
4. On the machine, press and hold the
until LED begins flashing (indicating machine is
ready to pair).
5. Press and hold the
flashing LED on machine will turn solid then
off when the remote has paired successfully.
NOTE: Remote needs to be within close proximity
to ensure remote is receiving signal from the ma-
chine. This procedure will time out in 30 seconds
if machine is not paired.
Removing/Installing the Backpack
The backpack can be removed for certain applica-
tions or for spot cleaning.
To remove the backpack, squeeze the backpack
latch and pull the backpack away from the machine.
NOTE: When used without a backpack, do not drag
the machine with the flexible shaft.
To install the backpack, line up the bottom hook and
secure the backpack to the machine base using the
backpack latch.
ONE-KEY™
To learn more about the ONE-KEY™ function-
ality for this machine, please refer to the quick
reference included with this machine or go to
milwaukeetool.com/One-Key. To download the
ONE-KEY™ app, visit the App Store or Google Play
from your smart device.
ONE-KEY™ Indicator
Solid Blue
Wireless mode is active and ready
to be configured via the ONE-KEY™
app.
Blinking Blue Machine is actively communicating
with the ONE-KEY™ app.
Blinking Red Machine is in security lockout and
can be unlocked by the owner via
the ONE-KEY™ app.
position.
button
button on the Remote;
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
Arming the Machine
The MX FUEL™ machines must be armed prior to
use. Even with the battery pack inserted, the machine
functions will not operate until the machine is armed.
To arm the machine:
1. Insert the battery pack.
2. Press the Arm button. The MX FUEL™ icon will
light.
3. After 15 minutes of inactivity, the machine will enter
sleep mode. The MX FUEL™ icon will go off and
the LEDs are un-operational.
4. Press and hold the Arm button for 1 second to
reactivate the machine.
5. Press and hold the ARM button for 1 second to
unarm (turn off) the machine. The MX FUEL™
icon will go off.
Starting and Stopping
1. Arm the machine.
2. To start the machine, set the switch to the
position.
3. To stop the machine, set the switch to the
position.
Starting and Stopping (Remote Mode)
1. Arm the machine.
2. On the machine, set the switch to the
3. Turn on the remote
4. To start the machine, press the
remote.
5. To stop the machine, press the
remote.
Cold Start LED
The Cold Start LED will illuminate when the machine
is started in cold conditions (below 32°F). The ma-
chine will will gradually bring the VPM up to 10,000
in order to avoid nuisance shutdowns. Once the VPM
reaches 10,000 VPM the Cold Start LED will go off.
This feature allows the machine to start in temps as
low as -4°F.
Low Battery Alert
During use, when the battery nears end of charge
(at 10% and 2% remaining charge), the machine will
notify the user by turning itself off and on (pausing).
Charge the battery.
5
position.
button on the
button on the
Publicité
