Télécharger Imprimer la page

Rittal CMC III Notice D'installation Et D'utilisation page 8

Publicité

Les langues disponibles

Les langues disponibles

EN
Notes on documentation, Safety instructions, Product description
1
Notes on documentation
This installation and short user guide is intended for experienced trained specialists and contains only
EN
the most important information concerning the assembly, installation and function of the
CMC III Analogue Air Flow Sensor (subsequently called air flow sensor).
1.1
Associated documents
CMC III Analogue Air Flow Sensor assembly and operating instructions.
It is available at www.rittal.com and contains the complete application-relevant information and techni-
cal data for the air flow sensor with regard to:
– Further assembly possibilities
– Functions
– Configuration possibilities
– Detailed operating instructions
– Troubleshooting
2
Safety instructions
– Assembly and installation of the air flow sensor may only be performed by experienced trained spe-
cialists.
– The air flow sensor housing must not be opened.
– The air flow sensor must not come in contact with water, aggressive or inflammable gases and va-
pours.
– The air flow sensor must only be operated within the specified environmental conditions (see
section 3.4).
– The tip of the sensor probe becomes very hot during operation (depending on the ambient temper-
ature up to 90 °C). To avoid burns, do not touch the tip of the sensor probe until it has had sufficient
time to cool down.
– Please note the assembly instructions in order to prevent damage to cables and other components
as a result of the high temperature.
3
Product description
3.1
Functional description
The air flow sensor measures and monitors the analogue air speed within a server enclosure, e.g. to
record the contamination level of a filter mat. It reports the measured air speed to the connected
CMC III PU. The air flow sensor has an identification that allows it to be detected automatically by the
CMC III PU.
3.2
Proper use
The CMC III Analogue Air Flow Sensor is used only to measure and monitor the analogue air speed
within a server enclosure. It may be used only together with the CMC III PU. Any other use is not per-
mitted.
3.3
Scope of delivery
– CMC III Analogue Air Flow Sensor
– Accessories supplied loose (fig. 1)
– Installation and Short User Guide
8
Rittal CMC III Analogue Air Flow Sensor

Publicité

loading

Ce manuel est également adapté pour:

Dk 7030.140