Publicité
Les langues disponibles
Les langues disponibles
Fitting
The fitting illustrations section in this user guide show the sequence
for obtaining the best fit and comfort when using your mask.
Fitting steps
Prior to fitting your mask, remove the elbow from the mask by
pressing the side tabs. Connect the elbow to your device air tubing.
1.
With both lower headgear straps released, hold the mask
against your face and pull the headgear over your head.
2.
Bringing the lower straps below your ears, loop the headgear
into the lower hooks on the mask frame.
3.
Unfasten the Velcro
until they are comfortable and reattach the Velcro. Do not
overtighten.
4.
Repeat step 3 with the lower headgear straps.
5.
Attach the combined elbow assembly and air tubing to the
mask by pressing the side-tabs and pushing into mask frame.
6.
Your mask and headgear should be positioned as shown.
Ensure the headgear label is facing outwards.
Removing the mask
Refer to the removal illustrations section in this user guide. To remove
your mask, disconnect one of the lower headgear hooks and pull the
mask and headgear up over your head.
Disassembly
Refer to the disassembly illustrations in this user guide.
Disassembly steps
1.
Unhook the upper headgear straps from the mask frame, there
is no need to undo the Velcro.
2.
Remove the combined elbow assembly and air tubing from the
mask by pressing the side-tabs and pulling away from the mask
frame. Remove the elbow assembly from the air tubing.
3.
Gently separate the cushion from the mask frame.
, pull the upper headgear straps evenly
®
3
Publicité
