Publicité
Les langues disponibles
Les langues disponibles
Reassembly
Refer to the reassembly illustrations in this user guide.
Reassembly steps
1.
Ensure the cushion is oriented correctly by aligning the top
cushion tab with the recess in the top of the mask.
2.
Gently pull the cushion through the front of the mask frame
until the cushion locks securely into the mask frame. The tabs
on either side of the cushion should be sitting against the mask
frame. Ensure the cushion is not twisted or distorted.
3.
Attach the top headgear straps to the mask frame by looping
onto each of the upper headgear hooks.
4.
Replace the elbow assembly into the air tubing and attach
the combined elbow assembly and air tubing to the mask by
pressing the side-tabs and pushing into the mask.
Cleaning your mask in the home
Your mask and headgear should only be gently handwashed.
Daily/After each use:
•
Disassemble the mask components according to the disassembly
instructions.
•
Thoroughly clean the separated mask components (excluding
headgear), by gently rubbing in warm (approximately 30°C) water
using mild soap.
•
To optimise the mask seal, facial oils should be removed from the
cushion after use.
•
Use a soft bristle brush to clean the vent.
•
Inspect each component and if required, repeat washing until
visually clean.
•
Rinse all components well with drinking quality water and allow to
air dry out of direct sunlight.
•
When all components are dry, reassemble according to the
reassembly instructions.
Weekly:
•
Handwash the headgear.
4
Publicité
