Publicité
Les langues disponibles
Les langues disponibles
WARNING
Do not use aromatic-based solutions or scented oils (eg,
eucalyptus or essential oils), bleach, alcohol or products that
smell strongly (eg, citrus) to clean any of the mask components.
Residual vapours from these solutions can be inhaled if not
rinsed thoroughly. They may also damage the mask.
CAUTION
If any visible deterioration of a system component is apparent
(cracking, crazing, tears etc), or, if after cleaning, any component
remains unclean, the component should be discarded and
replaced.
Reprocessing the mask between patients
This mask should be reprocessed when used between patients.
Cleaning, disinfection and sterilisation instructions are available from
the ResMed website, www.resmed.com/masks/sterilization. If you do
not have internet access, please contact your ResMed representative.
Troubleshooting
Problem/possible cause
Mask is too noisy
Vent is blocked or partially blocked.
Elbow incorrectly inserted.
Mask leaks around the face
Mask not positioned correctly.
Air leaking around the bridge of the nose.
Mask is not tightened correctly.
Solution
If the vent requires cleaning, use a
soft bristle brush.
Remove the elbow from the mask
and then reassemble according to
the instructions.
Gently pull the cushion away from
the face to reinflate. Reposition
your mask according to the
instructions.
Tighten top headgear straps. Do
not overtighten.
5
Publicité
