HIKOKI UC 3SML Mode D'emploi page 5

SPECIFICATION
CHARGER
Model
Charging voltage
Weight
Temperatures at which the battery can be recharged
APPLICATION
For charging the HiKOKI BATTERY EBM315.
CHARGING
Before using the power tool, charge the battery as follows.
1. Insert the charger connecting plug into the connecting
socket of the charger (Fig. 1)
2. Connect to the power source
When using the AC adapter
Plug the AC adapter into the power outlet.
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
When using the cigarette lighter connecting plug
○ Secure the battery charger in place in the car.
Use the strap supplied with the battery charger to
fasten the battery charger in place and prevent it from
moving inadvertently. (See Fig. 2)
CAUTION
Do not place the battery charger or battery under
the driver's seat. Secure the battery charger in
place to prevent it from moving inadvertently as this
may lead to an accident.
○ Insert the cigarette lighter connecting plug into the
cigarette lighter socket.
If the plug is loose and falls out of the cigarette lighter
socket, repair the socket. As the socket may be faulty,
you are recommended to contact your local car dealer.
Continued use of the socket may result in an accident
due to overheating.
3. Insert the battery in the charger
Position the battery so that the nameplate faces toward
the nameplate of the charger and press in the battery
until it comes into contact with the bottom plate (See
Fig. 1).
Inserting the battery will turn on the charger (the pilot
lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the power
cord from the receptacle and check the battery
mounting condition.
The pilot lamp goes off to indicate that the battery
is fully charged.
Fig. 2
0°C – 50°C
CAUTION
If the battery is heated due to direct sunlight, etc.,
just after operation, the charger pilot lamp may not
light. At that time cool the battery first, then start
charging.
○ Regarding recharging time
Table 1 shows the recharging time required according
to the type of battery.
Table 1 Recharging time (approx. min.) at 20°C
Battery
voltage
(V)
3.6 V EBM315
NOTE: The recharging time may vary according to the
ambient temperature.
4. Disconnect battery charger from the receptacle or
cigarette lighter socket
5. Hold the charger firmly and pull out the battery
NOTE
Be sure to pull out the battery from the charger after
use, and then keep it.
Regarding electric discharge in case of new batteries,
etc.
As the internal chemical substance of new batteries
and batteries that have not been used for an extended
period is not activated, the electric discharge might be
low when using them the first and second time. This is
a temporary phenomenon, and normal time required for
recharging will be restored by recharging the batteries
2-3 times.
How to make the batteries perform longer.
(1) Recharge the batteries before they become completely
exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery.
If you continue to use the tool and exhaust the electric
current, the battery may be damaged and its life will
become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the battery
and recharge it after it has cooled for a while.
English
UC3SML
3.6 V
0.2 kg
Battery capacity (Ah)
1.5 Ah
60 min.
5