HIKOKI UC 3SML Mode D'emploi page 4

English
GENERAL OPERATIONAL PRECAUTIONS
1. Keep work area clean. Cluttered areas and benches
invite accidents.
2. Avoid dangerous environment. Don't expose power
tools and charger to rain. Don't use power tools and
charger in damp or wet locations. And keep work area
well lit.
Never use power tools and charger near flammable or
explosive materials.
Do not use tool and charger in presence of flammable
liquids or gases.
3. The appliance is not intended for use by young children
or infirm persons without supervision. Young children
should be supervised to ensure that they do not play
with the appliance. All visitors should be kept safe
distance from work area.
4. Store idle tools and charger. When not in use, tools and
charger should be stored in dry, high or locked-up place
— out of reach or children. Store tools and charger in a
place in which the temperature is less than 40°C.
5. Don't abuse cord. Never carry charger by cord or yank
it to disconnect from receptacle. Keep cord from heat,
oil and sharp edges.
6. When the charger is not in use or when being
maintained and inspected, disconnect the power cord
of the charger from the receptacle.
7. To avoid danger, always use only the specified charger.
8. Use only genuine HiKOKI replacement parts.
9. Do not use power tools and charger for applications
other than those specified in the Handling Instructions.
10. To avoid personal injury, use only the accessories
or attachment recommended in these handling
instructions or in the HiKOKI catalog.
11. If the supply cord is damaged, it must be replaced
by the manufacture or its service agent or a similarly
qualified person in order to avoid a hazard.
Let only the authorized service center do the
repairing. The Manufacture will not be responsible
for any damages or injuries caused by repair by the
unauthorized persons or by mishandling of the tool.
12. To ensure the designed operational integrity of power
tools and charger, do not remove installed covers or
screws.
13. Always use the charger at the voltage specified on the
nameplate.
14. Always charge the battery before use.
15. Never use a battery other than that specified. Do not
connect a usual dry cell, a rechargeable battery other
than that specified or a car battery to the power tool.
16. Do not use a transformer containing a booster.
17. Do not charge the battery from an engine electric
generator or DC power supply.
18. Always charge indoors. Because the charger and
battery heat slightly during charging, charge the battery
in a place not exposed to direct sunlight; where the
humidity is low and the ventilation is good.
19. Use the exploded assembly drawing on this handling
instructions only for authorized servicing.
4
PRECAUTIONS FOR CHARGER
1. Always charge the battery at an ambient temperature of
10–40°C. A temperature of less than 10°C will result in
over charging which is dangerous. The battery cannot be
charged at a temperature greater than 40°C.
The most suitable temperature for charging is that of 20–
25°C.
2. Do not use the charger continuously.
When one charging is completed, leave the charger for
about 15 minutes before the next charging of battery.
3. Do not charge the battery for more than 2 hours.
4. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
5. Never disassemble the rechargeable battery or
charger.
6. Never short-circuit the rechargeable battery.
Short-circuiting the battery will cause a great electric
current and overheat. It results in burn or damage to the
battery.
7. Do not dispose of the battery in fire.
If the battery is burnt, it may explode.
8. Using an exhausted battery will damage the charger.
9. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery life
becomes too short for practical use. Do not dispose of
the exhausted battery.
10. Do not insert objects into the air ventilation slots of the
charger.
Inserting metal objects or flammable into the charger air
ventilation slots will result in an electrical shock hazard
or damage to the charger.
PRECAUTIONS WHEN USING THE BATTERY
CHARGER WITH A DC 12V IN-CAR POWER
SOURCE
1. Use the battery charger correctly.
Do not use the battery charger other than with a DC 12V
in-car power source. The battery charger is solely for
use on minus-grounded vehicles. Make sure that the
minus pole of the car battery is connected to the car
body.
2. Keep your attention focused on driving the car.
If you use the battery charger while driving, fasten
the battery charger in place so that it does not move
inadvertently and distract your attention from driving.
Do not place the battery charger or battery under the
driver's seat, irrespective of whether it is charging or
not, as it may get under the brake pedal or the cable
may get wrapped around the driver's feet and cause an
accident.
3. Do not manipulate the battery charger or battery while
driving as this may cause an accident.
4. Do not leave the battery charger or battery within reach
of children as this may result in an accident.
5. Be sure to use the cable provided.
Using a different cable could result in a fire or accident
due to overheating.
6. Do not place the battery charger on a blanket-type car
seat cover or car mat during charging as this may result
in a fire or accident due to overheating.
7. Do no expose the battery charger to direct sunlight
during charging as this may result in a fire.
8. Do not leave the vehicle unattended during charging.