System Setup; Connect Power; Connect Sources; Set Channel 1 & 2 Controls - Bose S1 Pro Guide D'utilisation

System Setup

Connect Power

1. Make sure the power switch is in Standby ( ).
2. Plug one end of the power cord into the connector on the S1 Pro.
3. Plug the other end of the power cord into a live electrical outlet.
4. Connect sound sources before turning the system on. See "Connect Sources" below.
5. Once the sound sources are connected, turn the system on by moving the power switch to On ( ).
Note: The Quick Charge (
information, see the battery accessory owner's guide, available at www.Bose.com.

Connect Sources

Before plugging in a sound source, adjust all channel Volume controls fully counterclockwise.
Set Channel 1 & 2 Controls
Channel 1 and 2 are for use with dynamic microphones, guitars, keyboards or other instruments.
1. Before connecting your microphone or instrument, adjust the Volume control for the appropriate
channel fully counterclockwise.
2. Channels 1 and 2 are equipped with an integrated ToneMatch® preset to automatically optimize the
sound of your microphone or instrument. If desired, apply the ToneMatch preset by moving the
ToneMatch switch for the appropriate channel to
3. While speaking into the microphone or playing your instrument, adjust the volume to the desired level
by slowly turning the Volume control clockwise.
4. Adjust the Treble, Bass, and Reverb controls to make further refinements based on your personal
preference. While speaking into the microphone or playing your instrument, slowly adjust the control
until desired effect is achieved.
8 - Owner's Guide
) power setting is for use with the battery accessory only. For more
for microphones or for other instruments.