Peg-Perego duette sw 2008 Notice D'emploi page 10

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: READ THE INSTRUCTIONS CAREFULLY BEFORE USE
AND KEEP THEM FOR FUTURE REFERENCE. THE CHILD MAY BE
HURT IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
_ THIS PRODUCT IS DESIGNED FOR CHILDREN WHOSE MAXIMUM
WEIGHT IS 45 POUNDS (20 KG) AND WHOSE MAXIMUM HEIGHT IS 43
INCHES (110 CM). THIS SHOPPER BASKET IS DESIGNED TO CARRY
A MAXIMUM WEIGHT OF 11 POUNDS (5 KG). ANY POACH OR POCKET
PROVIDED WITH THIS UNIT IS DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 0.44 POUNDS (0.2 KG).
_ FAILURE TO FOLLOW MANUFACTURER'S SPECIFICATIONS OR
USE OF ACCESSORIES OTHER THAN THOSE APPROVED BY THE
MANUFACTURER MAY CAUSE THE UNIT TO BECOME UNSTABLE.
_ AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT. ALWAYS
USE COMPLETE 5 POINT SEAT BELT.
_ NEVER LEAVE YOUR CHILD UNATTENDED.
_ ALWAYS USE ALL THE BRAKES WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY, WHEN MAKING ADJUSTMENTS ENSURE
THE CHILD'S BODY IS CLEAR OF ALL MOVING PARTS.
_ ALL OPERATING AND ASSEMBLY PROCEDURES SHOULD BE
PERFORMED BY AN ADULT.
_ DO NOT LIFT THE STROLLER BY GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO WITHSTAND LOADS.
_ ENSURE THAT THE STROLLER IS OPENED CORRECTLY AND LOCKED
IN POSITION OF USE.
_ CHECK TO MAKE SURE THAT THE CAR SEAT OR THE BABY
CARRIAGE IS CORRECTLY FASTENED TO THE STROLLER (WHERE
APPLICABLE).
_ DO NOT DRIVE THIS PRODUCT AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON STAIRS OR ESCALATORS.
_ DO NOT USE THE PRODUCT IF IT HAS BROKEN OR MISSING PARTS.
_ DO NOT USE NEAR FIRE OR EXPOSED FLAME.
_ NOTICE: THIS ARTICLE MEETS OR EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD AND LATEST REVISIONS.
INSTRUCTIONS
1 FITTING THE WHEELS: remove the four protective caps, (two round and two square) from
the folded chassis, as in the figure.
2 WARNING: distinguish the front wheels (Fig. A) from the rear wheels (Fig. B), as in the figure.
3 Fit the front wheels, which are shown in Figure A, while the base is closed. It is necessary
to push the locking lever down (fig. B) and at the same time push the hub onto the pin (fig.