Alarm Configuration - Bodet HARMONYS Notice D'utilisation Et D'installation

3.4 Alarm configuration

This page is used to enable device supervision, to define the information to be transmitted
and the destination server. One or more settings can be defined and configured as alarms.
The following information is displayed:
- SNMP : activates the SNMP network service for device supervision
Enable checkbox
from a control PC.
- Version: choice of SNMP protocol version.
- Community: A set of clocks defined by the user. All the clocks on the network must have
the same Community name.
- Tick SNMP Trap box: activates (or not) the automatic sending of error messages to
SNMP managers.
- SNMP Manager 1/2/3 : IP addresses of servers receiving alerts from the clocks. SNMP
Manager redundancy increases the reliability of alerts.
23