Connecting the rear fog lamp and the back-up light
14. Connect the brown wires with the eyelet to the vehicle's ground point (Fig. 1/1).
15. Lay the remaining fivefold connector assembly (Fig. 1/2) in the side section on the left-hand
side and connect it to the original connector assembly.
Disconnect the black connector assembly and connect it to the appropriate mating plugs
-
of the cable harness.
Fasten the connector assembly properly.
-
16. Activation of C2 trailer monitoring light.
Recode the vehicle's electrical system control unit, using the Service Tester
-
(e.g. VAG 1552).
Select function 07 (code control unit) under address 09 and set the trailer coupling option
-
to "1".
Note
If you have any queries concerning the coding procedure, please contact the nearest garage.
Checking correct operation
17. Reconnect the ground of the vehicle's battery.
18. Check the trailer function with the help of a suitable test instrument (with load resistors) or
with the help of a trailer.
19. Secure all cables using cable ties.
20. Refit any parts removed for installation.
18
344 041 391 101 - 16/03
Installation Instructions:
Electrical System for Towing Hitch
Seat Cordoba