Westfalia 344 041 300 107 Instructions De Montage page 17

Installation Instructions:
Electrical System for Towing Hitch
Installing the electrical kit
1. Disconnect the negative battery terminal.
2. Remove the following coverings:
•
In the luggage trunk
Luggage trunk floor cover
-
Covering of the rear end plate
-
Covering of the right and left tail light
-
Covering of the left rear trunk side
-
3. Drill a 19 mm hole for the cable leadthrough in the vehicle's rear end below the left tail light
near the luggage trunk floor (Fig. 1/3).
4. Starting in the luggage trunk, lead the socket end of the cable harness through the cable
leadthrough to the outside up to the socket holder plate (Fig. 1/5).
5. Fit the rubber grommet and insert it into the cable leadthrough (Fig. 1/4).
Socket installation
6. Fit the socket gasket and connect the cable harness to the socket housing in accordance with
the pin assignment plan (Fig. 1/5) and push the rubber grommet against the socket.
7. Screw the socket onto the holder plate (Fig. 1/5) using the supplied screws and nuts.
8. Secure the cable harness using cable ties.
Connecting the tail lights
9. Lead the cable end with the gray/red cable along the rear end plate to the right-hand tail light
(Fig. 1/6).
10. Unplug the plug of the right-hand tail light and connect it to its counterpart on the cable
harness. Plug the residual plug back into the tail light. Make sure that the plugs lock firmly into
place.
11. Secure the cable on the rear end plate.
12. Lead the cable end with the gray/black cable to the left-hand tail light (Fig. 1/3).
13. Unplug the plug of the left-hand tail light and connect it to its counterpart on the cable
harness. Plug the residual plug back into the tail light. Make sure that the plugs lock firmly into
place.
Seat Cordoba 344 041 391 101 - 16/03 17