Indel B Cruise 49 Mode D'emploi page 9

CRUISE
REPLACING THE DOOR PANEL
On the Cruise 42–49-50-65-85-100-130 models, you can replace the door panel without having to dis-
mantle the door of the refrigerator, by proceeding as follows: remove the profile which anchors the
panel, locate at the bottom of the door, using a screwdriver as a lever as shown on Fig 6, take out the
three screws which hold the handle in place (fig. 8), fit in the new panel, letting it slide, and put back
the fastening strip and the handle.
REVERSING THE OPENING DIRECTION OF THE DOOR
On the Cruise 42–49-50-65-85-100-130 models, the door normally opens towards the right. To change the
side, move the hinges, the support (A, B and C in fig. 7) and the handle (fig. 8).
SETTING THE INSIDE TEMPERATURE
The refrigerators are provided with a manual thermostat. Turn it clockwise to lower the temperature, and
turn it counterclockwise to raise the temperature and activate the ON-OFF switch in its end position.
In the 42, 49, 50, 65, 85 and 130 litre refrigerators, the knob of the thermostat is located inside the
refrigerator. In the 100 litre refrigerators, the knob is located outside the refrigerator, on the top ventila-
tion grid, above the door.
FILLING
Do not put hot food into the refrigerator. Place the products in a position where they do not hit each other
or break while the vehicle is moving.
Make sure the door is always well closed, and reduce opening time to a minimum.
DEFROSTING
Defrosting must be carried out when the ice layer is thicker than 4 mm.
Set the thermostat at the OFF position. While defrosting, keep food and beverages in a cool place. Do not
use any sharp metal object to remove the ice or frost. Do not start the refrigerator up again until it is
completely defrosted and dry. Also empty the tray under the freezer compartment.
MAINTENANCE:
The refrigerators have a completely watertight cooling system, and do not need any mainte-
nance or reloading of the coolant. The compressor is of a domestic type, is highly efficient and has an
extraordinarily long life.
Maintenance merely consists in routinely cleaning the condenser from dust, at least once a year. Use a
soft brush and no hard object.
• Regularly clean the inside and outside of the refrigerator using only warm water and a neutral detergent.
• Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.
• Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray detergents,
alcohol, ammonia or abrasive products.
• If you are not using the minibar, we suggest cleaning it well inside and leaving the door ajar to ventilate
the interior. To do so, release the lock of the door using a coin or a small screwdriver (fig. 1 and 2).
USEFUL ADVICE
If it does not work, or works wrongly before referring to our after sales service, make sure that:
a) power is not missing.
b) the voltage which reaches the station is equal to the one shown on the plate.
c) the connections are wrongly made.
d) the flapped condenser is not jammed.
e) the refrigerating unit is not near a source of heat.
f) the fuse mounted on the feeding line is not blown.
CRS_06-09-2017
ENGLISH
9