Indel B Cruise 49 Mode D'emploi page 8

ENGLISH
WIRING SYSTEM: FUNCTIONS AND FEATURES
The Station of the compressor is a piece of electronic equipment which pilots the motor of the compressor
and carried out all the controls and electrical protection of the system. Its main features are the following:
a) Protection of the battery with automatic turning off of the compressor when the feeding voltage reaches
the minimum threshold (cut out)
The compressor will start up automatically again when the voltage goes back to normal values (cut in).
TABLE FOR BATTERY SAVER INTERVENTION VOLTAGES
WIRING CONNECTIONS
When you connect the refrigerator, you must remember the following:
1) Use cables having the proper cross section (see the table) to make the feeding lines. If possible, such
cables should be without any joints on the leads which could lead to voltage falls.
2) If the wiring system of the vehicle is insufficient or not properly sized for the refrigerator, we suggest
you connect it directly to the battery.
Note The use of cables having an insufficient cross section may lead to the compressor stopping even
when the battery is charged.
CROSS SECTION CABLES mm
2.5
4
6
10
3) Any switches must have a breaking load not less than 20 A (10 A if powered at 24 Volt).
4) Make sure the polarity is right: connect the red cable to the positive terminal (+) and the black cable to
the negative terminal (-).
Warning!
Never connect bare electric wires, and use only connectors of a size suitable to the cross section of the
cable being used.
5) Protect the feeding line with a 15 A fuse.
8
FEEDING
12 V
24 V
2
CUT OUT
9,5 V
21 V
Maximum length of cables in metres
12 V
2.5
4
6
10
CRUISE
CUT IN
11 V
23 V
24 V
5
8
12
20
CRS_06-09-2017