Cleaning And Maintenance; Cleaning Of The Machine; Maintenance - Merand AQUAPAN 75 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

25.

CLEANING AND MAINTENANCE

25.1.

CLEANING OF THE MACHINE

After each use or after a full time work you should do the following cleaning
operations:
Realise de machine and clean all the used accessories: blades, mould of
cut... these accessories can be cleaned with water and soap, but having to by
dry after been cleaned.
Hover or blow at all the left over's of flower in the machine. Throw any rest of
mass that is left over.
Clean the transportation bands, first with a brush to take out the flower,
after with a humid cloth with soap.
Make the lone advance to clean all its way and clean underneath the lone.
To clean the table and the other elements of the stainless structure its
recommended to use a specific product to clean stainless steel.
25.2.

MAINTENANCE

The machine has been designed for a low normal maintenance, putting in
nearly all of the parts long life greasy elements.
Anyway, there are some operations that next to the good cleaning of the
machine, will help to a longer life of the machine.
In the lamination head: Grease manually the chain of transmission, the
graduation columns and the tension and centring of the lone, use lithium
grease.
Check weekly the tension and centring of the lone.
All the operations detailed should be revised with a shorter time that the
indicated if the condition of the machine needed it.
Page 59
H.BERDER 10/04/2012

Publicité

Table des Matières
loading

Table des Matières