Menu Selection Parameters - Merand AQUAPAN 75 Manuel D'instructions

24.2.3. MENU SELECTION PARAMETERS

Pressing the icon SELECTION PARAMETERS of the principal menu we will
access to the following screen:
On the screen there will appear some squares with the names of the different
parts of the machine. Pressing on the values we can change the function
parameters of the different parts. The parameters that you can change are
the following:
ENTRY TABLE: Indicates the speed of the entrance table to the lamination.
Expresses the lineal speed in in HZ the function of the engine,
LAMINATION: Indicates the speed of the multi-roller above the lamination.
The frequency is expressed in HZ the function of the engine.
EXIT TABLE: Indicates the speed of the exit band of the guillotine. Expresses
the lineal speed in HZ the function of the engine.
CUT LENTH: Indicates the distance in millimeters that will wind on on the
transporting band between each cut of the guillotine.
These parameters only introduced as a reminder, not affecting the operation
of the machine;
HEIGHT ROLLER: Indicates the value that the digital indicator of the multi-
roller should mark and it expresses the height of the lamination of the
machine. This action hasn't got any effect on the machine mechanisms,
because you can adapt it manually.
SPADES SEPARATION: Indicates the value that marks the rules of the
guides of the beginning. This action hasn't got any effect on the machine
mechanisms, because you can adapt it manually.
Page 57
H.BERDER 10/04/2012