Check And Set Angle Display (Fig. 4); Setting The Sanding Table Angle (Fig. 5); Connecting The Vacuum Cleaner (Fig. 6); Working With The Disc Sander Tsg 250/E - Proxxon TSG 250/E Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
Your TSG 250/E is normally operated with the
attached sanding table (as in delivery condition).
But it is also possible to remove the sanding
table if required for certain work tasks or when
changing the sanding discs.
1. Unscrew Allen screws 1
2. Take off sanding table 2 together with the
housing cover 3
3. To attach, simply insert the sanding table
together with the housing cover back in the
normal position
4. Screw Allen screws 1 back in and tighten.

6.3 Check and set angle display (Fig. 4):

Attention:
Before doing any adjusting work, always discon-
nect the mains plug to prevent the disc from
starting up inadvertently. Risk of injuries!
The angle display is set accurately by the fac-
tory. The angle stop can be easily readjusted,
should this ever be necessary:
1. Release both clamping screws 1
2. Align work table 2 with an angle to exactly
90° as shown in Fig. 4
3. Retighten clamping screws 1
4. Release screw 3 slightly and correct the
„zero" position of indicator 4 as necessary.
5. Re-tighten screw 3
6.4 Setting the sanding table angle
(Fig. 5):
Attention:
Before setting the sanding table, always discon-
nect the mains plug to prevent the disc from
starting up inadvertently. Risk of injuries!
To chamfer boards or slats, for example, we rec-
ommend placing these objects on the pivoted
table. Also refer to Fig. 5a. Set the chamfer
angle as follows:
1. Release the right and left clamping screws 1
(Fig. 5)
2. Swivel sanding table 2 to the required angle
position and check the set value on angle
scale 3.
- 14 -
3. Retighten clamping screws 1.
6.5 Connecting the vacuum cleaner
(Fig. 6):
Attention:
Before connecting the vacuum cleaner, always
disconnect the mains plug to prevent the disc
from starting up inadvertently. Risk of injuries!
We recommend you always work with the vac-
uum cleaner! This not only guarantees clean
work but also reduces the harmful effect of
some dusts!
1. Slide rubber adapter 1 onto suction connec-
tion 2
2. Insert vacuum cleaner nozzle 3 in rubber
adapter 1
3. Switch on vacuum cleaner while working
Here's another tip:
Using the Proxxon CW-matic vacuum cleaner
omits that annoying manual activation and
deactivation. The CW-matic is equipped with an
automatic control that switches on and off auto-
matically whenever the electrical tool is acti-
vated or deactivated. You have the same effect
with commercially available vacuum cleaners
when using our AS/E vacuum cleaner controller.
7 Working with the disc sander
TSG 250/E:
Safe and accurate work is only possible with
careful fastening!
Never leave an activated device unsupervised.
1. Switch on the disc sander.
2. Adjust the rotational speed of the sanding
disc with speed controller 1 (Fig. 1).
3. Place the work piece on the work table and
guide with sensitivity and little force.
4. Exert more pressure on the work table and
less pressure against the sanding disc.
Caution!

Publicité

Table des Matières
loading

Table des Matières