HERKULES BKS 315/230 Mode D'emploi D'origine page 14

Anleitung_BKS_315_230_SPK7__ 07.08.14 14:27 Seite 14
GB
Caution:
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Safety Information
Please refer to the booklet included in delivery for the
safety instructions!
CAUTION
Read all safety regulations and instructions. Any
failures made in following the safety regulations and
instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1 Saw table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Universal stop
8 Hand crank
10 Table extension
11 Switch/plug block
12 Clamping screw
13 Extractor hose
14 100 mm diameter extractor connection
15 Chassis
16 Push handles
17 Chip box
18 Leg
19 Leg with opening
21 Thumb screw
23 Clamping rail
24 Strut
25 Rubber feet
27 Guide rail for cross stop
29 Mounting for extractor hose
30 Engine
14
3. Items supplied
Bench-type circular saw
Carbide-tipped saw blade
Universal stop
Push stick
Table extension
Tool
Chassis
4. Proper use
The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross stop) of
all types of timber, commensurate with the machineʼs
size.
The machine is not to be used for cutting any type of
roundwood.
The machine is to be used only for its prescribed
purpose.
Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse. The machine is to be
operated only with suitable saw blades (saw blades
made of HM or CV) It is prohibited to use any type of
HSS saw blade and cutting-off wheel. To use the
machine properly you must also observe the safety
regulations, the assembly instructions and the
operating instructions to be found in this manual.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about the machineʼs potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design: