Introduction; General Information; Responsibility; Manual - Husqvarna HTC 270 EG Manuel De L'opérateur

HTC 270 EG
1

Introduction

1.1

General Information

HTC 270 EG is a grinder that can be used to grind, strip, clean and polish concrete,
unhewn stone and terrazzo as well as wood floors. The machine's area of application
depends on the choice of tool.
Read the manual carefully, so you are totally familiar with the machine before you start
to use it. Contact your local retailer for further information. For contact information, see
Contact Information at the start of the manual.
1.2

Responsibility

Even though every effort has been made to make this manual as complete and accurate
as possible, we bear no responsibility for incorrect or missing information. HTC
reserves the right to change descriptions in this manual without giving prior notice.
This manual is protected by the Copyright Act and no part of it may be copied or used
in any other way without the written approval of HTC.
1.3

Manual

In addition to the general functions, this manual deals with the areas of application and
the maintenance of the grinder.
1.3.1 Safety Instructions – Explanation of Symbols
A number of symbols are used in the manual to highlight the most important sections,
see below. In order to avoid both personal injury and material damage as far as possible,
it is extremely important to read and understand the text next to these symbols
particularly carefully. There are other symbols indicating practical tips. These are to
help you use the machine in the easiest and most effective way.
The following symbols are used in the document to indicate where special attention is
needed.
Warning!
This symbol means Warning! and indicates that incorrect use can result in
material damage to the machine or accessories. If you see this symbol next to a
section of text, you must be particularly careful when reading through the text
and not carry out any stages of which you are unsure. This is for your own and
other users' safety and to avoid damage to machinery or other equipment.
2.0
Introduction
1