Hayward AquaVac 300 Guide De L'utilisateur page 12

Aquavac Drive
1. For installation and normal use of AquaVac Drive, please refer to the chapter on general use.
2. In order for the remote control to operate properly, the power supply box must be placed in an
unobstructed location about twenty metres from the remote control. The remote control can be used at any
time during the cycle without the cycle being interrupted.
3. In order to control AquaVac Drive, press and hold the buttons of the remote control that correspond to the
action you wish to perform. Once you have released the button, AquaVac Drive automatically resumes its
normal cycle.
If AquaVac Drive does not operate when you press the button:
- Check that you are pointing the remote control towards the power supply box and not towards AquaVac.
- Check that there is no obstacle between the power supply box and the remote control
The distance between the power supply box and the remote control should be no longer than 20 metres.
The closer you are to the power supply box, the better the reception.
- Check the battery of the remote control: if necessary, replace it with a new battery (1x CR2032 Lithium).
- The voltage surge protection might have tripped. Reactivate it by depressing the button located above the
connection of the AquaVac power supply cable on the power supply box.
- Check that the rotation actuator is not clogged with debris. For this purpose, remove AquaVac from the
water, and operate the actuator by hand to clear the debris: the actuator should be able to move easily.
Aquavac Quick Clean
1. For installation and normal use of AquaVac QC, please refer to the chapter on general use.
2. In order to select the normal cycle or the economy cycle, please follow the following instructions: on
switching on, the economy programme is automatically selected. The "Quick Clean" light, situated on the
control box, then comes on. In this mode, AquaVac will switch off automatically after 90 minutes.
3. In order to select the normal programme, please press the "Full Cycle" button. The light situated above
the button comes on and indicates that the normal programme is running. In this mode, AquaVac will switch
off automatically after 4 hours.
If the economy mode is finished, you should switch off Aquavac and then switch it back on in order
to select normal mode: normal mode can be selected only during an economy cycle.
Warning : Robotic cleaner equipped with Foam :
First run : Remove plastic sleeve protecting the foams before using the cleaner.
Do not use sharp tools to remove this plastic sleeve in order to avoid foams deterioration.
Put the cleaner in the water to soak the foams as they must be wet, press the foams with both hands under
water to speed the process.
Repeat the above process before each use.
12