Technical Data; Installation - Zanussi ZFU27400WA Notice D'utilisation

Problem
There is too much frost.

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance should be installed in a dry,
well ventilated indoor where the ambient tem-
perature corresponds to the climate class indi-
cated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
22
Possible cause
Many products are stored at the
same time.
Products are too near to each oth-
er.
Food is not wrapped correctly.
The temperature regulator is not
set correctly.
Height
Width
Depth
Store less products at the same
time.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Set a higher temperature.
1850 mm
595 mm
658 mm
18 h
230 - 240 V
50 Hz
Some functional problems might occur for
some types of models when operating outside
of that range. The correct operation can only
be guaranteed within the specified tempera-
ture range. If you have any doubts regarding
where to install the appliance, please turn to
the vendor, to our customer service or to the
nearest Service Centre
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circu-
late freely around the back of the cabinet. To
ensure best performance, if the appliance is
positioned below an overhanging wall unit, the
minimum distance between the top of the cab-
inet and the wall unit must be at least 100
mm . Ideally, however, the appliance should
not be positioned below overhanging wall
Solution
www.zanussi.com