Battery Connection And Positioning - LEGRAND KEOR HPE Manuel De Fonctionnement

Installation and start-up of KEOR HPE UPS 60÷160 kVA
Installation et démarrage de l'ASI KEOR HPE 60÷160 kVA
Installazione e avviamento KEOR HPE UPS 60÷160 kVA
Internal batteries
The UPS can have internal batteries.
 Servicing of batteries should performed by qualified personnel only.
 Replace the batteries with the same number of block and capacity.
 Replace only with original type.
 CAUTION: do not dispose of batteries in fire. The battery may explode.
 CAUTION: do not open or mutilate batteries. Released electrolyte is harmful to
the skin and eyes. It may be toxic.
 CAUTION: do not dump the exhausted batteries in the environment.

4.4.1 Battery connection and positioning

Battery voltage
After the battery installation, before closing BCB, check the battery voltage on the
BCB circuit breaker.
In case of not directly supplied cabling, please connect the cables to the battery
breaker (BCB) as shown in the below picture.
Picture 9 – Cabling of BCB fuse holder
OML46086 REV. I 37