How To Remove The Battery Pack - Hayward AquaVac 250 Manuel D'utilisation

 Do not expose the battery to fire or intense heat as this may result in an explosion.
CAUTION!
If a battery leak occurs, avoid any contact with the leaking fluids and place the damaged battery
in a plastic bag.
If leaking fluids come in contact with skin and clothing, wash immediately with plenty of
-
soap and water.
If leaking fluids come in contact with eyes, do not rub eyes, immediately flush eyes with
-
cool running water for at least 15 minutes and do not rub them. Seek medical attention as
soon as possible.
How to remove the battery pack (To be done by authorized technician) Recommended
tools (not included): Screwdriver.
Follow section "EMPTYING THE DEBRIS COMPARTMENT" to release the top
1.
cover (preassembled with the swivel head). Place the cover upside down and use the
screwdriver to unfasten the screw on the bottom locking plate. Turn the bottom locking
plate anticlockwise to release the swivel head. Remove the swivel smoothening-ring.
2. Use the screwdriver to unscrew the 4 screws located at the bottom of the head to
release the bottom plate first, then unscrew all the screws at the base as shown. Remove
the impeller and pry open the base to expose the head inside.
3. Remove the battery pack to expose the PCBA. To detach the battery connection
wire, press on the clip of the connector to pull it out. NOTE: Wrap the connector
immediately with insulating tape in order to avoid any short circuit caused by the contact
of both wire terminals.
16