Bumper; Pool Preparation - Hayward AquaVac 250 Manuel D'utilisation

NOTE: In case the robot is moving in circle or cannot cover the entire pool, set the tube B to
position " " as below:
Note: You will hear a "click" sound everytime you adjust the fin.

Bumper

Use of the bumper is optional and can be applied in the following situation:
If the robot tends to follow the perimeter of a round pool, clipping a bumper on each side of
the robot will eliminate this pattern.

Pool Preparation

- If there are stones, roots or metal corrosion in contact with the underside of the liner,
discard them prior to using the robot. If necessary, seek assistance from a qualified professional.
- If the liner is brittle, damaged or wrinkled, contact a qualified professional to perform the
necessary repairs or perform a liner replacement prior to using the robot.
- Remove any pool ladder, surface skimmer, and other floating objects from the pool as
they may obstruct the movement of the robot's float and, consequently, the movement of the
robot also.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the robot
into the water.
IMPORTANT NOTE: Turn off the filtration system (as instructed in your filtration manual)
at least 15 minutes prior to deploying the robot.
11