Table des Matières
Publicité
NOTE:
FACE OF HEATER
ELEMENT SHIELD MUST BE
BEHIND KNIFE EDGE OF
STATIC KNIFE
TO SQUARE THE HEATER UNIT WITH THE PRESS ARM, RAISE THE PRESS ARM & HOLD THE OUTSIDE
FACE OF THE HEATER ELEMENT SHIELD AGAINST THE RUBBER PLATEN OF THE PRESS ARM. TIGHTEN
THE M6 SOCKET HEX CAP SCREWS WHILE MAINTAINING EVEN CONTACT BETWEEN THE PRESS ARM
2
RUBBER PLATEN & THE HEATER ELEMENT SHIELD.
Heater Unit & Press Arm Cylinder Assembly
(Temporary Seal)
NOTE:
PLACE A DROP OF
LOC-TITE 242 ON THE
3
THREADS OF EACH
CAP SCREW PROIR
4
TO ASSEMBLY
NOTE:
Rev. 260109
72
6
1
5
NOTE:
HEATER ELEMENT WIRE
HARNESS HAS BEEN OMITTED
TO IMPROVE CLARITY
Publicité
Table des Matières
