Table des Matières
Publicité
1
NOTES:
1.
MACHINE CHASSIS SUPPORT HAS NOT BEEN SHOWN TO IMPROVE PICTORAL CLARITY
2.
DO NOT OVERTIGHTEN ELASTIC M5 HEX LOCKNUT (ITM #10 ). TIGHTEN THE ELASTIC
HEX LOCKNUT UNTIL THERE IS NO SIDEPLAY IN THE KNIFE PIVOT ARM. DYNAMIC KNIFE
PIVOT ARM MUST MOVE FREELY.
3.
TO SET THE DYNAMIC KNIFE, HOLD THE DYNAMIC KNIFE BLADE AGAINST THE STATIC
KNIFE BLADE UNTIL CONTACT. TIGHTEN THE M3 SOCKET HEX CAP SCREWS WHILE
KEEPING THE TWO KNIFE BLADES IN CONTACT.
2
5
3
4
C
17
16
1
Dynamic Knife Assembly
(new knife Temporary Seal)
6
7
8
67
10
15
11
12
14
13
Publicité
Table des Matières
