Operation; Replace Or Recharge Battery; Shut Appliance Down; Care And Maintenance - Birchmeier REC 15 AZ1 Mode D'emploi

3. Operation

Spraying
Operating the trigger valve will spray the agent. The spray pattern can be adjusted by turning the nozzle head
in the following ways.
Flow
Fanjet nozzle XR 8004 VS
Pressure
[bar]
1
2
3
4
5
6
* Operational state can't be attained
LED display on sprayer
The appliance shows you the current state of charge and also has an automatic switch-off function, which
produces an error code (blink code).
Permanently lit = battery's state of charge:
Green: > 50 %
Yellow: 30 – 50 %
Red: < 30 %
1x red flash (10 repetitions) = battery empty
2x red flash (10 repetitions) = overheating of the electronics
3x red flash (10 repetitions) = the pressure is not reaching 0.5 bar. (Tank empty, Pump defect, suction
hose blocked, inlet valve blocked)
4x red flash (10 repetitions) = auto Power off due to non-use during 15 minutes
5x red flash(10 repetitions) = security cut off motor controlling
6x red flash (10 repetitions) = pressure sensor failure (electronics need to be changed)

4. Replace or recharge battery

Unlock the battery by pressing the latch and slide it out.
Slide the battery into the fast charger and start charging.
The battery reaches its maximum capacity after ca. 4 charging/discharging cycles.
For detailed information please consult the separate user's manual regarding battery power.

5. Shut appliance down

Turn the appliance off.
After use the appliance must be emptied; never store the spray-liquid in the sprayer.(Please ensure the
correct disposal of any residue).
Turn the appliance on again and spray until no more fluid escapes (empties the air vessel).
Refill with clean water (max. 30 °C / 80 °F) and rinse through thoroughly until only air escapes the nozzle.
If the battery is not used for a long period of time, remove the battery and recharge it. Do not store the
battery in the charging device after recharging.
VI Care and maintenance
Store the equipment away from the effects of frost. For storage, the spray-tube can be hooked onto the
retaining ring.
Nozzles and filters (trigger) must be periodically cleaned or replaced.
Do not clean the nozzle with hard objects, nor blow through it using the mouth (danger of poisoning). The
most suitable cleaning device is a nail-brush or tooth-brush.
Gaskets are subject to wear and must be monitored regularly, and eventually replaced.
To dry the appliance, leave it standing in an open position.
Please be aware that the appliance may be subject to national requirements for regular inspection by
designated bodies, as provided for in Directive 2009/128/EC of the European Parliament.
Spray angle 80°
[litres / minute]
0.91
1.29
1.58*
1.82*
2.04*
2.23*
- 17 -