Sony SU-WL100 Mode D'emploi page 9

3
Adjust the angle of the Mounting
Hook.
When installing the TV parallel to the wall (0 degrees),
adjustment of the Mounting Hook angle (procedures
1 and 2 below) is not necessary.
1 Remove the angle adjusting screw from the arm of
the Mounting Hook. Choose the holes
corresponding to the desired angle (5, 10, 15 or 20
degrees).
2 Firmly secure the arm using the screw removed in
the previous procedure 1.
Mounting Hook
Arm
CAUTION
Be careful not to pinch your fingers when adjusting the angle
of the Mounting Hook.
1
2
4
Secure the Mounting Hook to the
right side of rear of the TV.
1 Secure the Mounting Hook to the rear of the TV
temporarily, using the supplied two screws (+PSW4
× 12).
2 Be sure that both screws are tightened securely with
equal torque strength to the rear of the TV.
If you adjusted the left angle of the Mounting Hook,
also perform the same adjustment as in 3 of Step 5
"Adjust the angle of the Mounting Hook" for the right.
Notes
• Be sure to adjust the right and left arms to the same angle.
• Make sure that the two arm bases are screwed in securely.
Screw
(+PSW4 × 12)
Mounting
Hook
9
(GB)